| ladsm.com http://www.ladsm.com/forum/ |
|
| A'pexi safc2 install info http://www.ladsm.com/forum/viewtopic.php?f=7&t=10969 |
Page 1 of 1 |
| Author: | FUZZYDSMTUNNER [ Thu Mar 18, 2010 6:37 pm ] |
| Post subject: | A'pexi safc2 install info |
Anyone here knows where I can go to get a apexi safc2 installed and possibly installed or a on line link that I can go to install it my self any thank fuzz |
|
| Author: | turboawdfanatic [ Thu Mar 18, 2010 8:39 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
Um, did you think of trying these guys? http://www.apexi-usa.com/  seriously though, installation instructions and wiring diagrams are available on this page: http://www.apexi-usa.com/info/?id=5383 I'ts pretty straight forward. Just be sure you look at the correct wiring diagram for your car. Cross reference the ECU pin outs on the VFAQ if you wish. |
|
| Author: | FUZZYDSMTUNNER [ Thu Mar 18, 2010 10:02 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
found someone |
|
| Author: | turboawdfanatic [ Thu Mar 18, 2010 11:29 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
It's a pretty simple job. I wouldn't pay someone to do it if I were you. Plus, do you know what kind of quality electrical they do? They might just tap splice everything rather than use solder or good quality butt connectors. |
|
| Author: | slidesidwayz [ Sat Mar 17, 2012 5:11 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
Is tap splicing a bad way to do it? |
|
| Author: | Illeagle [ Tue Mar 20, 2012 3:33 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
those vampire taps? worst things ever. Cut>solder>heastrink>then tape. Saves you a headache in the future. |
|
| Author: | turboawdfanatic [ Fri Mar 23, 2012 1:48 pm ] |
| Post subject: | Re: A'pexi safc2 install info |
If you can't solder, at the very least get  Here's a great article from MotoIQ on various splice options that are actually good (note that OE wiring uses crimp connectors): http://www.motoiq.com/magazine_articles ... lices.aspx I *really* wish I had read this article about 15 years ago. Would have avoided a lot of issues and had more long term reliability. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|