| ladsm.com http://www.ladsm.com/forum/ |
|
| bend valves repair shop http://www.ladsm.com/forum/viewtopic.php?f=5&t=5495 |
Page 1 of 2 |
| Author: | charleslester08 [ Mon Sep 22, 2008 7:44 am ] |
| Post subject: | bend valves repair shop |
| Author: | Illeagle [ Mon Sep 22, 2008 12:01 pm ] |
| Post subject: | |
Machine shop will check your valves out, replace the bent ones, and re-deck your head. Valves $8 each. Stem Seals $32 for all 16 Guides $6 each ARP studs $105 Head Gasket $100 Machining at my local machine shop in long beach will be around $140 and they do good work. |
|
| Author: | charleslester08 [ Mon Sep 22, 2008 12:17 pm ] |
| Post subject: | |
is the studs mandatory? |
|
| Author: | christ [ Mon Sep 22, 2008 12:28 pm ] |
| Post subject: | |
| Author: | charleslester08 [ Mon Sep 22, 2008 12:37 pm ] |
| Post subject: | |
| Author: | 98gsxMr.Beans21 [ Mon Sep 22, 2008 1:11 pm ] |
| Post subject: | |
| Author: | SOADweskey [ Mon Sep 22, 2008 1:33 pm ] |
| Post subject: | |
| Author: | arash15 [ Mon Sep 22, 2008 1:36 pm ] |
| Post subject: | |
| Author: | Illeagle [ Mon Sep 22, 2008 2:34 pm ] |
| Post subject: | |
| Author: | christ [ Mon Sep 22, 2008 3:57 pm ] |
| Post subject: | |
| Author: | Illeagle [ Mon Sep 22, 2008 4:10 pm ] |
| Post subject: | |
| Author: | 98gsxMr.Beans21 [ Mon Sep 22, 2008 4:18 pm ] |
| Post subject: | |
| Author: | charleslester08 [ Mon Sep 22, 2008 5:18 pm ] |
| Post subject: | |
| Author: | charleslester08 [ Mon Sep 22, 2008 5:21 pm ] |
| Post subject: | |
| Author: | SOADweskey [ Mon Sep 22, 2008 6:11 pm ] |
| Post subject: | |
Follow the timing belt instructions on to set the timing right. Pretty much just line up all the timing marks and use a screw driver to make sure that you balance shaft isn't 180degs out. |
|
| Page 1 of 2 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|