ladsm.com http://www.ladsm.com/forum/ |
|
2g auto gsx http://www.ladsm.com/forum/viewtopic.php?f=5&t=15511 |
Page 1 of 1 |
Author: | slidesidwayz [ Sun Feb 09, 2014 3:19 pm ] |
Post subject: | 2g auto gsx |
I just got a 2g auto gsx. When I first drove it, it would go in reverse but the rpm would go a bit high before moving even slowly (3000 rpm). After driving an hour to my house, I tried going in reverse again but this time no matter how much I gassed it it never moved. Why would my reverse just go out like that? What needs to be done to get me up and running again? Thanks in advance. Note: The car is almost 100% stock with 190k on the odo. It has an intake and exhaust. |
Author: | -red97rum- [ Tue Feb 11, 2014 1:24 pm ] |
Post subject: | Re: 2g auto gsx |
I just replied to your PM. Check the things I listed in that PM first, fluid level etc etc. Don't forget to check the fluid after the trans is warm and idling in neutral, not park. I'd buy a new filter and pull out the valvebody and check the o-ring that sits up above it. If that o-ring is damaged or not sealing properly you'll lose reverse for sure. The o-ring I'm talking about is mentioned in this IPT video. It's worth having a look, as it's not very difficult to pull the pan and valvebody to get to it. |
Author: | slidesidwayz [ Wed Feb 12, 2014 12:04 pm ] |
Post subject: | Re: 2g auto gsx |
Where can that be purchased? Can it be purchased on its own? I can't tell from the vid if it is just a normal oring or a special piece. |
Author: | slidesidwayz [ Wed Feb 12, 2014 12:28 pm ] |
Post subject: | Re: 2g auto gsx |
Do you think it would come in this kit? |
Author: | -red97rum- [ Wed Feb 19, 2014 10:30 am ] |
Post subject: | Re: 2g auto gsx |
I'm sure it would come in that kit. From what I remember when I put in my shift kit, it's just an ordinary o-ring. You should be able to pick one up from a parts store that's the same diameter and just replace it. |
Author: | slidesidwayz [ Wed Feb 19, 2014 12:50 pm ] |
Post subject: | Re: 2g auto gsx |
Thanks, it should be getting rebuilt this Friday so hopefully it gets taken care. Did you go with the IPT shift kit? |
Author: | -red97rum- [ Mon Feb 24, 2014 10:37 am ] |
Post subject: | Re: 2g auto gsx |
If it's getting rebuilt, then yes, it definitely should take care of the problem. IPT sells the shift kit made by "Trans Lab" I got mine off of the dsmtuners classifieds for like $40 a couple years ago. It's the same one IPT sells though. |
Author: | slidesidwayz [ Mon Feb 24, 2014 4:19 pm ] |
Post subject: | Re: 2g auto gsx |
I'll look into that thanks. Would you recommend just getting the rebuilt valve body from IPT directly? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |