Is this block usable or should I just send it in to get it rebuild??
When I pulled the head which piston is gone??
#3 Piston
Can you find the compression ring??
| ladsm.com http://www.ladsm.com/forum/ |
|
| Check out my 6 bolt lol http://www.ladsm.com/forum/viewtopic.php?f=5&t=12837 |
Page 1 of 1 |
| Author: | Wally [ Sat May 21, 2011 6:44 pm ] |
| Post subject: | Check out my 6 bolt lol |
Is this block usable or should I just send it in to get it rebuild?? When I pulled the head which piston is gone?? #3 Piston Can you find the compression ring??
|
|
| Author: | awdmonster [ Sat May 21, 2011 8:55 pm ] |
| Post subject: | Re: Check out my 6 bolt lol |
wally thats a melted piston go .20 over oem 2g pistons and youre set |
|
| Author: | clockworktoy [ Mon May 23, 2011 1:28 pm ] |
| Post subject: | Re: Check out my 6 bolt lol |
Pull the motor and take it to a legit machine shop. Have em check how bad the damage on the sidewalls are and if you can go 20 over then time for a build. |
|
| Author: | -red97rum- [ Mon May 23, 2011 3:34 pm ] |
| Post subject: | Re: Check out my 6 bolt lol |
Yep, you might have been pinging a little bit when that happened 
|
|
| Author: | Black_gst [ Tue May 24, 2011 7:36 am ] |
| Post subject: | Re: Check out my 6 bolt lol |
Its still good, drop it in and go! |
|
| Author: | bras_33 [ Tue May 24, 2011 2:11 pm ] |
| Post subject: | Re: Check out my 6 bolt lol |
if it weren't for bad luck, you would have no luck at all... |
|
| Author: | Erix [ Sat Jun 25, 2011 7:20 pm ] |
| Post subject: | Re: Check out my 6 bolt lol |
that wasn't even your motor! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|