Re: Noise coming out from first gear
Well I just bled my clutch again and the noise is still there. Im starting to think something is up with my flywheel here is why. When I took it to them (machine shop) I told them to resurface the flywheel and make sure it was at the correct step height. Turns out all they did was just resurface the flywheel. Reason I bring this up I ran into a thread and said the part where the pressure plate bolts on to need to be stepped. I went over to the machine and found this out to that they did not do this at all. What should be some symptoms of a improperly stepped flywheel and a powder coated starter plate. I know when you powder coat something it gets thicker or should it not matter. Im saying like maybe space out the tranny from the engine. Im at a lost here and also could the improperly stepped flywheel cause my TOB to start dying so early. One more thing can the flywheel not being stepped cause chatter??. I should say the flywheel was not stepped at AT ALL!!!. Am I looking at another clutch job