| ladsm.com http://www.ladsm.com/forum/ |
|
| How to install a BSEK? http://www.ladsm.com/forum/viewtopic.php?f=5&t=11762 |
Page 1 of 1 |
| Author: | So_CalXDSM [ Mon Aug 16, 2010 9:23 pm ] |
| Post subject: | How to install a BSEK? |
Ive never seen a thread on how to do this? How exactly is it done on a 6 bolt oil pump? |
|
| Author: | 805dsmALEX [ Mon Aug 16, 2010 11:07 pm ] |
| Post subject: | Re: How to install a BSEK? |
http://www.vfaq.com/mods/balance-shafts.html |
|
| Author: | So_CalXDSM [ Tue Aug 17, 2010 12:04 am ] |
| Post subject: | Re: How to install a BSEK? |
Damn! That shit looks like a mission! |
|
| Author: | fmedgsx [ Tue Aug 17, 2010 12:32 am ] |
| Post subject: | Re: How to install a BSEK? |
its one of things that are easier said than done. |
|
| Author: | DSM99 [ Tue Aug 17, 2010 11:37 am ] |
| Post subject: | Re: How to install a BSEK? |
Thats something way easier to do when the engine is out of the car. IMO it's not even worth the hassel to do it unless the motor is out. |
|
| Author: | clockworktoy [ Tue Aug 17, 2010 7:23 pm ] |
| Post subject: | Re: How to install a BSEK? |
Are you building a motor? Are you balancing the rotating assembly? If no then don't do this mod. Its a PIA, and if you ask its already way over your head. Believe me its not worth the time and effort to do. |
|
| Author: | So_CalXDSM [ Tue Aug 17, 2010 10:59 pm ] |
| Post subject: | Re: How to install a BSEK? |
Yes i am rebuilding a 6 bolt which is why i want to do this since the engine is gonna be worked on outside the chasis. And depending on my economic status in a couple weeks i might balance the assembly. How much is a basic balance? Average? |
|
| Author: | fmedgsx [ Wed Aug 18, 2010 1:31 am ] |
| Post subject: | Re: How to install a BSEK? |
It all depends on how far you are taking the balancing weither you are including the flywheel, the crank pulley and the rotating assembly. if you are just doing the rotating assembly then it should only run a couple hundred bucks |
|
| Author: | So_CalXDSM [ Wed Aug 18, 2010 9:04 am ] |
| Post subject: | Re: How to install a BSEK? |
Is there stages to balance an assembly? |
|
| Author: | fmedgsx [ Wed Aug 18, 2010 12:03 pm ] |
| Post subject: | Re: How to install a BSEK? |
No I dont think there ever should have been "stages" for performance parts because one persons stage is different than another and the stages tell us nothing about the product. most of the time depending on your goals people just balance the rotating assembly. but do not balance the clutch with it if anything only do the flywheel and pulley with the rotating assembly. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|