| ladsm.com http://www.ladsm.com/forum/ |
|
| Intake Question http://www.ladsm.com/forum/viewtopic.php?f=5&t=11373 |
Page 1 of 1 |
| Author: | Oscardms [ Thu May 27, 2010 6:04 pm ] |
| Post subject: | Intake Question |
So the car I got has a PVC intake and doesn't have the bov recirculated. I was looking into getting a dejon intake. Here's my problem. I have a greddy 18g and the outer diameter of the inlet is about 3.25". Now I can either get the dejon in 3" or 3.5" piping. I have no clue what to do. |
|
| Author: | Tsi_AWD_Talon [ Thu May 27, 2010 6:19 pm ] |
| Post subject: | Re: Intake Question |
| Author: | Oscardms [ Thu May 27, 2010 7:24 pm ] |
| Post subject: | Re: Intake Question |
Well the dejon adapter is only 2.5" piping. My question was, which one would be best, 3" or 3.5" since I know I'll need some type of adapter, unless the 3.5" coupler can be compressed enough to fit over the 2.25" without an issue. |
|
| Author: | rdengineering [ Thu May 27, 2010 8:01 pm ] |
| Post subject: | Re: Intake Question |
i dont see the benefit of going larger than 3" in your case... R |
|
| Author: | Oscardms [ Thu May 27, 2010 8:53 pm ] |
| Post subject: | Re: Intake Question |
| Author: | SOADweskey [ Thu May 27, 2010 9:28 pm ] |
| Post subject: | Re: Intake Question |
If your turbo inlet is 3.25 then you should get the 3.5" intake and get a 3.5 to 3.25 reducer coupler to put it on. |
|
| Author: | DSM99 [ Fri May 28, 2010 12:59 am ] |
| Post subject: | Re: Intake Question |
| Author: | Oscardms [ Fri May 28, 2010 12:56 pm ] |
| Post subject: | Re: Intake Question |
| Author: | SOADweskey [ Fri May 28, 2010 2:38 pm ] |
| Post subject: | Re: Intake Question |
I've never had a Dejon intake so I don't know about the nipples. As for your turbo being 3.125" OD, in my experiences a 3.25" coupler will compress enough and it will be fine since you are on the no-pressurized side of the compressor. |
|
| Author: | Tsi_AWD_Talon [ Fri May 28, 2010 3:45 pm ] |
| Post subject: | Re: Intake Question |
| Author: | clockworktoy [ Fri May 28, 2010 6:33 pm ] |
| Post subject: | Re: Intake Question |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|