J-B WELD
| ladsm.com http://www.ladsm.com/forum/ |
|
| oil feed from head seal http://www.ladsm.com/forum/viewtopic.php?f=4&t=9095 |
Page 1 of 1 |
| Author: | twisted metal [ Wed May 27, 2009 6:11 pm ] |
| Post subject: | oil feed from head seal |
Ok so I feed my turbo from the filter housing and seal the head feed spot with a bolt. Now I broke the bolt off in the head and its one of the oil feed bolts that are hollow so I'm gonna shoot oil everwhere. Now I don't have a way to remove the broken bolt without driving the car somwhere. How should I seal the hole? |
|
| Author: | 4GRIDER [ Wed May 27, 2009 6:19 pm ] |
| Post subject: | Re: oil feed from head seal |
J-B WELD
|
|
| Author: | twisted metal [ Wed May 27, 2009 6:51 pm ] |
| Post subject: | Re: oil feed from head seal |
That was my first though I just don't know if it will handle the pressure and I also need to know if I can just seal it or does oil need to flow through there. Only reason I think that is because its a banjo bolt (I'm not sure if that's what its called) my other thought was to hammer a nail in there then use the jbweld over the head of the nail. |
|
| Author: | gordonbradford [ Wed May 27, 2009 7:40 pm ] |
| Post subject: | Re: oil feed from head seal |
You can just jb weld it. But if it was me i would use an easy out and just put a new bolt in. |
|
| Author: | 4GRIDER [ Wed May 27, 2009 7:52 pm ] |
| Post subject: | Re: oil feed from head seal |
Yea tru taking the old be better could get worst, and get particals inside your head |
|
| Author: | Erix [ Thu May 28, 2009 12:43 am ] |
| Post subject: | Re: oil feed from head seal |
screw in another thinner bolt into the hole in the banjo bolt 
|
|
| Author: | gordonbradford [ Thu May 28, 2009 1:10 am ] |
| Post subject: | Re: oil feed from head seal |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|