| ladsm.com http://www.ladsm.com/forum/ |
|
| Tune up + hydraulic lifters advice?? http://www.ladsm.com/forum/viewtopic.php?f=4&t=7372 |
Page 1 of 1 |
| Author: | AllMotor DSMer [ Thu Nov 13, 2008 5:47 pm ] |
| Post subject: | Tune up + hydraulic lifters advice?? |
| Author: | Illeagle [ Thu Nov 13, 2008 6:35 pm ] |
| Post subject: | |
Rockers are fine. When you say tune up, you mean timing belt and all of it? if so cam seals, front main seal, balance spricket seal, oil pump seal, valve cover gasket, spark plug grommets gaskets. |
|
| Author: | AllMotor DSMer [ Thu Nov 13, 2008 6:57 pm ] |
| Post subject: | |
| Author: | Illeagle [ Thu Nov 13, 2008 7:05 pm ] |
| Post subject: | |
| Author: | AllMotor DSMer [ Thu Nov 13, 2008 7:11 pm ] |
| Post subject: | |
| Author: | 1fast2G [ Fri Nov 14, 2008 12:34 am ] |
| Post subject: | |
| Author: | AllMotor DSMer [ Fri Nov 14, 2008 10:56 am ] |
| Post subject: | |
| Author: | Illeagle [ Fri Nov 14, 2008 12:58 pm ] |
| Post subject: | |
Springs and Ret. aren't needed. It depends on the cam profile. If its a really agressive high lift, high duration, and quick ramp rate cam then yes springs and retainers. But if its some 264 and most 272 variant, then no. |
|
| Author: | AllMotor DSMer [ Fri Nov 14, 2008 1:10 pm ] |
| Post subject: | |
| Author: | Illeagle [ Fri Nov 14, 2008 2:25 pm ] |
| Post subject: | |
| Author: | AllMotor DSMer [ Fri Nov 14, 2008 2:52 pm ] |
| Post subject: | |
| Author: | Illeagle [ Fri Nov 14, 2008 3:21 pm ] |
| Post subject: | |
| Author: | AllMotor DSMer [ Fri Nov 14, 2008 3:29 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|