Thanks,
I bought one. $212 shipped.\
Nothing else I could find that would work, but maybe a stock replacement one, and cut off some of the pipe. I ordered the reducers w/ my MAFT, which u wont need in this case w/ this INJEN TOOL one.
_small.jpg)
| ladsm.com http://www.ladsm.com/forum/ |
|
| I/C piping (MAFT) http://www.ladsm.com/forum/viewtopic.php?f=4&t=4090 |
Page 1 of 1 |
| Author: | HBWaterfowler [ Fri Jun 06, 2008 1:15 pm ] |
| Post subject: | I/C piping (MAFT) |
| Author: | 805dsmALEX [ Fri Jun 06, 2008 2:25 pm ] |
| Post subject: | |
| Author: | HBWaterfowler [ Mon Jun 09, 2008 10:09 am ] |
| Post subject: | |
Thanks, I bought one. $212 shipped.\ Nothing else I could find that would work, but maybe a stock replacement one, and cut off some of the pipe. I ordered the reducers w/ my MAFT, which u wont need in this case w/ this INJEN TOOL one.
|
|
| Author: | HBWaterfowler [ Sun Jun 15, 2008 9:51 pm ] |
| Post subject: | |
| Author: | braceyoself777 [ Sun Jun 15, 2008 10:30 pm ] |
| Post subject: | |
| Author: | HBWaterfowler [ Mon Jun 16, 2008 12:56 pm ] |
| Post subject: | |
Cool. Well I got that $600 tax check. So I'm making it happen. I was looking at the install picture for the dejon kit. It look like the reducers will work. If you look at the kit, it goes from 2.5 to 3" to match the maf. So... the space is small. But! The hose they give u does not go all the way up on the maf, it doesn't even go over the nipple that holds it on. So, there should be room for the reducer. I will need the 3.5 to 3 reducer. They are freakin $23 ec., kinda pricey. But if it makes the 3.5" work then fuk it... 
|
|
| Author: | HBWaterfowler [ Thu Jun 19, 2008 1:57 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|