well a few days ago after i arrived here in Oxnard my engine decides to drop a valve in cyl 1 and destroyed the piston and now i have to pull the engine out and clean it out of all the metal .
i need to use an engine stand to properly clean and re-hone all cylinders cause wile im at it ill put another set of rings and main and rod bearings ,front cover oil pump then ill send the head in to the machine shop for valves and springs
there is some scoring in the cylinders that i dont like and i can see it becoming a problem for compression being that my brother drove it and ran it out of oil 2 times leaking oil line i found
i just rebuilt this engine 4,000 miles ago and had 4 turbos puke on this car and found the oil pump was weak replaced that before i left mn and now i have to do it again . i need to get all the bad out and away with it i really dont want to end up doing this again ..
