| ladsm.com http://www.ladsm.com/forum/ |
|
| 1G Eagle Talon Build http://www.ladsm.com/forum/viewtopic.php?f=4&t=12013 |
Page 1 of 2 |
| Author: | Mr Casual [ Thu Oct 14, 2010 9:14 pm ] |
| Post subject: | 1G Eagle Talon Build |
So i'm building my car and thought I would share what's going on so far Sony stereo New Rear Trunk Shocks New Master Cylinder Re installed AC Re Installed Fog Lights and Horn Sony Speakers all Around Full break Down of the motor and everything looks good. Up Grades Punishment front mount Timing belt kit ARP Head Studs FP Mani Greddy type Bov Water pump BC Valves Bc 272 cams BC Valve springs That's just the start. Patients is a virtue!!!
|
|
| Author: | awdmonster [ Thu Oct 14, 2010 11:11 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | -red97rum- [ Fri Oct 15, 2010 9:08 am ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | Mr Casual [ Fri Oct 15, 2010 1:56 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | -red97rum- [ Fri Oct 15, 2010 3:23 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | Mr Casual [ Tue Oct 19, 2010 9:59 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
Bosch Knock Sensor Gates Thermostat ITM 3rd Gen lifters all on the way |
|
| Author: | awdmonster [ Mon Nov 22, 2010 12:52 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | 50trimanic [ Mon Nov 22, 2010 8:55 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
Put it together and tune it, take it to the Track and see what it do!!LOL.....And i just put those itm 3g lifters and there great not even a tick when i start it.....dont rush it.............. |
|
| Author: | Mr Casual [ Mon Nov 22, 2010 9:45 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
It's hard not to throw it together. I'm sure Hugos tired of looking at it for the last few months in his driveway. The motor is just about done. Only a couple of bolts and a gasket and done. I'm saving for the tranny flywheel and clutch. With Christmas coming soon it will probly not be until late Jan. I'll post some pics this week.
|
|
| Author: | Mr Casual [ Wed Dec 08, 2010 9:00 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
![]() ![]() ![]()
|
|
| Author: | 50trimanic [ Thu Dec 09, 2010 10:13 am ] |
| Post subject: | Re: 1G Eagle Talon Build |
why leave the balance shafts still in? |
|
| Author: | awdmonster [ Thu Dec 09, 2010 10:44 am ] |
| Post subject: | Re: 1G Eagle Talon Build |
Coming along quite nicely |
|
| Author: | Mr Casual [ Fri Dec 10, 2010 8:43 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | Mr Casual [ Fri Dec 10, 2010 8:45 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
| Author: | Mr Casual [ Tue Mar 08, 2011 8:55 pm ] |
| Post subject: | Re: 1G Eagle Talon Build |
Finally got it started last weekend sounds good. then noticed the Rad leaking and some othe little things so should be up and rolling by this weekend. I hope.
|
|
| Page 1 of 2 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|