| ladsm.com http://www.ladsm.com/forum/ |
|
| Hey I'm new! http://www.ladsm.com/forum/viewtopic.php?f=30&t=2429 |
Page 1 of 2 |
| Author: | SpiderMatt89 [ Sat Jan 12, 2008 2:49 am ] |
| Post subject: | Hey I'm new! |
| Author: | Erix [ Sat Jan 12, 2008 2:58 am ] |
| Post subject: | |
| Author: | BOOST [ Sat Jan 12, 2008 7:42 am ] |
| Post subject: | |
| Author: | SOADweskey [ Sat Jan 12, 2008 9:38 am ] |
| Post subject: | |
| Author: | clockworktoy [ Sat Jan 12, 2008 11:05 am ] |
| Post subject: | |
| Author: | Project2G [ Sat Jan 12, 2008 11:52 am ] |
| Post subject: | |
| Author: | SpiderMatt89 [ Sat Jan 12, 2008 3:17 pm ] |
| Post subject: | |
| Author: | BOOST [ Sat Jan 12, 2008 3:19 pm ] |
| Post subject: | |
| Author: | onecks787 [ Sat Jan 12, 2008 4:59 pm ] |
| Post subject: | |
| Author: | ghetto_bird [ Sat Jan 12, 2008 11:27 pm ] |
| Post subject: | |
| Author: | SpiderMatt89 [ Sun Jan 13, 2008 2:29 am ] |
| Post subject: | |
I love the spool on it. Seriously it starts boosting at about 2.5k rmps. I am only running 5 psi of boost because right now my internals are stock and I am waiting to get billet made pistons rods and crank and then I want to re-enforce the block. Actually if you have any info on where I could get those parts that be really tight. I would take forged parts too if I could find them. Yeah I will be at the bbq for sure 
|
|
| Author: | ghetto_bird [ Sun Jan 13, 2008 8:33 am ] |
| Post subject: | |
billit ha how much is the the set up. because i have wiseco piston and eagle rods annd i'm jsut boosting 6 pounds with a massive boost leak. how much boost are yoiu planing to run when your done with your setup . and i'm not sure about reinforcing the block it slef. our blocks can handel a lot because it has the bed plate holding the crank. so it good to go. unless you waht to go at the speed of light then yhea you might have to. my goal is to break into 13's (13.909 @ 1/4)that will be good |
|
| Author: | awesome_asim187 [ Sun Jan 13, 2008 2:54 pm ] |
| Post subject: | |
| Author: | SpiderMatt89 [ Sun Jan 13, 2008 3:14 pm ] |
| Post subject: | |
| Author: | Chamuko [ Sun Jan 13, 2008 4:16 pm ] |
| Post subject: | |
| Page 1 of 2 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|