| ladsm.com http://www.ladsm.com/forum/ |
|
| Lifters/lifter tick http://www.ladsm.com/forum/viewtopic.php?f=26&t=7436 |
Page 1 of 1 |
| Author: | clockworktoy [ Tue Nov 18, 2008 7:43 pm ] |
| Post subject: | Lifters/lifter tick |
| Author: | Illeagle [ Tue Nov 18, 2008 7:56 pm ] |
| Post subject: | |
| Author: | christ [ Tue Nov 18, 2008 8:06 pm ] |
| Post subject: | |
If you want to do that, make sure you take the cams over too and put the lifters exactly where they sat on each lob before the swap. You can use new lifters on a new or used cam, but not the other way around. They're already wore into a pattern with the lobe. |
|
| Author: | clockworktoy [ Tue Nov 18, 2008 8:17 pm ] |
| Post subject: | |
According to V faq they're suppose to be different 
From what they say the hole up top is the same on the 2g and 3g lifters but the side feed is bigger on the 3g lifters. If i do end up doing this ill probably do one at a time, thanks for the advice christ. |
|
| Author: | DimondStar [ Tue Nov 18, 2008 9:18 pm ] |
| Post subject: | |
Wow interesting. So basically the 1g and 2g heads are the same but cams and lifters.? |
|
| Author: | clockworktoy [ Tue Nov 18, 2008 9:24 pm ] |
| Post subject: | |
| Author: | 1fast2G [ Wed Nov 19, 2008 2:01 am ] |
| Post subject: | |
| Author: | clockworktoy [ Wed Nov 19, 2008 12:28 pm ] |
| Post subject: | |
| Author: | Illeagle [ Wed Nov 19, 2008 12:34 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|