ladsm.com http://www.ladsm.com/forum/ |
|
smim http://www.ladsm.com/forum/viewtopic.php?f=26&t=10254 |
Page 1 of 1 |
Author: | twisted metal [ Fri Nov 13, 2009 5:32 pm ] |
Post subject: | smim |
so my friend is moving back from florida and we have been talking about designing a sheet metal intake manifold. he has all the tools for sheet metal work and used to work as a fabracater for a few off road shops and sand rail shops building aluminum wings, and bodies for sand rails. question is if we could develop some for cheep would anyone be interested? |
Author: | chinexican [ Fri Nov 13, 2009 6:31 pm ] |
Post subject: | Re: smim |
i might be if he could make one for the 420a.... all i can find for it is cheap ass obx or expensive ass venom.... |
Author: | twisted metal [ Sat Nov 14, 2009 10:31 am ] |
Post subject: | Re: smim |
im sure we can we wont have a test car though to see if it actually helps |
Author: | so.cal.2g [ Fri Nov 27, 2009 8:02 am ] |
Post subject: | Re: smim |
have you seen all motor mikes intake mani for the 420? thing is sick with a 400 dollar price tag but definitely the best and only intake mani ive really seen... the intake runners are shorter and inlet is bored out for a 60mm tb. i believe the intake runners are ported and polished i'm not to sure, i was gonna go this route before i sold my dsm you should look it up on tuners and dyno proven by bulletdsm so you know your getting a quality a manifold and work is top notch... not junk like obx |
Author: | Synthetek [ Sun Nov 29, 2009 4:26 pm ] |
Post subject: | Re: smim |
Author: | clockworktoy [ Sun Nov 29, 2009 7:09 pm ] |
Post subject: | Re: smim |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |