so my friend is moving back from florida and we have been talking about designing a sheet metal intake manifold. he has all the tools for sheet metal work and used to work as a fabracater for a few off road shops and sand rail shops building aluminum wings, and bodies for sand rails. question is if we could develop some for cheep would anyone be interested?

i might be if he could make one for the 420a....
all i can find for it is cheap ass obx or expensive ass venom....

im sure we can we wont have a test car though to see if it actually helps

have you seen all motor mikes intake mani for the 420? thing is sick with a 400 dollar price tag but definitely the best and only intake mani ive really seen... the intake runners are shorter and inlet is bored out for a 60mm tb. i believe the intake runners are ported and polished i'm not to sure, i was gonna go this route before i sold my dsm you should look it up on tuners and dyno proven by bulletdsm so you know your getting a quality a manifold and work is top notch... not junk like obx