| ladsm.com http://www.ladsm.com/forum/ |
|
| 2g fwd dp http://www.ladsm.com/forum/viewtopic.php?f=24&t=15241 |
Page 1 of 1 |
| Author: | whitegsx97 [ Sun Jun 02, 2013 12:52 pm ] |
| Post subject: | 2g fwd dp |
If any one has a 2g evo 3 flange fwd down pipe lmk i need one. 3 2 3-8 9 9-7 0 5 4 |
|
| Author: | red92tsi [ Mon Jun 03, 2013 10:30 am ] |
| Post subject: | Re: 2g fwd dp |
I have one but not sure if it was made for evo3 though - was from a part out. Any way to tell short of putting it on a car? It is stainless 2.5 up to the flex section and 3 afterwards. |
|
| Author: | 92DSMer [ Wed Jun 05, 2013 12:24 am ] |
| Post subject: | Re: 2g fwd dp |
The 2g should bolt up to an Evo3 no problem? |
|
| Author: | whitegsx97 [ Sat Jun 15, 2013 2:14 pm ] |
| Post subject: | Re: 2g fwd dp |
I have a dp but it seems as evo 3 flange curves my dp has a flex section still not enough it leaks. |
|
| Author: | Synthetek [ Sat Jun 15, 2013 3:38 pm ] |
| Post subject: | Re: 2g fwd dp |
RRE sells the EVO III down pipe flange, you can cut it and weld on a new flange at the correct angle. |
|
| Author: | LOLVTEC [ Sat Jun 15, 2013 4:49 pm ] |
| Post subject: | Re: 2g fwd dp |
I think Luis wants a bolt on plug and play lol Sent from my iPad using Tapatalk |
|
| Author: | Synthetek [ Sat Jun 15, 2013 5:12 pm ] |
| Post subject: | Re: 2g fwd dp |
Then RRE is the only one I know of that makes an EVO III flanged downpipe for DSMs |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|