| ladsm.com http://www.ladsm.com/forum/ |
|
| FS or Trade: PTE GT32 http://www.ladsm.com/forum/viewtopic.php?f=15&t=7391 |
Page 1 of 1 |
| Author: | flipdsm [ Sun Nov 16, 2008 12:48 am ] |
| Post subject: | FS or Trade: PTE GT32 |
| Author: | Synthetek [ Sun Nov 16, 2008 5:42 am ] |
| Post subject: | |
| Author: | flipdsm [ Sun Nov 16, 2008 1:13 pm ] |
| Post subject: | |
Ok, my bad, heres the info. I have a PTE GT32 w/ mitsu hotside that I want to trade for a genuine Evo III 16g. The flapper is welded shut and is setup for wastegate on the manifold. It has about 10k miles on it with 0 in and out shaft play and 1/16" side to side. I hit full boost around 3800-4000rpm with this turbo, its basically a 50 trim with a lighter wheel. There are no broken bolts or studs, it will come with an oil feed & drain fittings (not the lines). Reason I am getting rid of it is because I want something smaller and a quicker spool. If nobody has a Evo 16g, I will let it go for $500 +shipping. Heres some pics before I installed it:
|
|
| Author: | flipdsm [ Sat Nov 22, 2008 10:17 pm ] |
| Post subject: | |
| Author: | SOADweskey [ Sun Nov 23, 2008 10:32 am ] |
| Post subject: | |
| Author: | flipdsm [ Sun Nov 23, 2008 11:15 am ] |
| Post subject: | |
| Author: | braceyoself777 [ Mon Nov 24, 2008 1:39 pm ] |
| Post subject: | |
| Author: | flipdsm [ Thu Nov 27, 2008 1:26 am ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|