ladsm.com
http://www.ladsm.com/forum/

6 bolt bare block, 6 bolt heads and other misc.
http://www.ladsm.com/forum/viewtopic.php?f=15&t=14799		 Page 1 of 1
Author:  mglasseydsm [ Sun Sep 16, 2012 11:30 pm ]
Post subject:  6 bolt bare block, 6 bolt heads and other misc.
Selling a 6 bolt bare block bored 20 over..its almost perfectly clean and ready for internals. $200

6 bolt heads i have 2 of them. Fully ready to drop in with stock cams. $200 each.

2 more sets of stock cams..$40 each

1g FWD trans 150$

1g rear end $150

1g rods that were reconditioned and are pretty much new. $125

2g tail lights..almost new $50

2g smoked tail lights $50

1g 255 wally fuel pump used...40$

22 spine tranfer case $200..pretty new and perfectly clean.

Another 6 bolt block with a crank anlready in it. $220

Stock cranks i have 3..$50 each.

1g intake manifold $40

2g intake manifold $30

stock exhaust manifold i have 2... 30$ each

other stuff will be listed soon.
Author:  LambdaJoker [ Mon Sep 17, 2012 12:49 pm ]
Post subject:  Cranks
Do you have any 6 bolt cranks that are in good condition?
Author:  LOLVTEC [ Mon Sep 17, 2012 1:12 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
What year is the tranny

Sent from my LG-P999 using Tapatalk 2
Author:  mglasseydsm [ Mon Sep 17, 2012 4:44 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
yes all of the cranks are in good condition..been garaged.

and the tranny i believe is from a 93 fwd turbo.
Author:  LOLVTEC [ Tue Sep 18, 2012 1:40 am ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
whats the condition of the tranny? grinding>
Author:  mglasseydsm [ Tue Sep 18, 2012 11:38 am ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
Tranny is in good condition. A little dirty like most but not bad. No grinds at all. I can send you a picture when i get home on friday??
Author:  LambdaJoker [ Tue Sep 18, 2012 1:00 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
So if I take a mic to the crank, all of the journals will be within spec and not out of round? None were ground smaller?
Author:  mglasseydsm [ Wed Sep 19, 2012 12:13 am ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
If you really want me to bust out a micrometer and check it out then i will..but i havent looked personally
Author:  dsmturbo1g [ Mon Sep 24, 2012 12:52 am ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
Can u send pics of block 951-490-1323
Author:  charleslester08 [ Mon Sep 24, 2012 9:10 am ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
ill take the 6bolt block :)
Author:  Achelea [ Mon Sep 24, 2012 6:18 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
The wally still available? I'm rounding out my excuse list for not fully tuning my car. :P Wally, FPR, injectors, replacement 16g.
Author:  mglasseydsm [ Tue Sep 25, 2012 9:47 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
yes the wally is still available..and both the 6 bolt blocks. Keep in mind one is bare and the other has the 6 bolt crank..i have another crank for the bare block and 1g rods if needed by any of you..dsmturbo1g i will get you pics friday when i get home from school.
Author:  slowpokedsm [ Thu Apr 04, 2013 8:13 pm ]
Post subject:  Re: 6 bolt bare block, 6 bolt heads and other misc.
Would you trade the 6bolt head for a 7bolt head ready to drop in as well.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/