#1
MachV 2g center vent gauge holder. 2x 52mm.
Looks like

$55

#2
Brand new K&N 4.5" x 6" air filter. Should work with any 2g MAF adapters. I accidentally ordered 2 of them.
$30

#3
Evo III Oil Filter Housing
OEM crush washers already installed
2 -8AN fittings already installed
New OEM 7-bolt OFH Gasket
New PROPER 4 bolts and lock washers to mount it.
Already drilled and tapped for the OEM dummy light




As you can see, there is a piece broken off around the tip of where the oil filter goes that a sensor normally hangs from. Came to me that way from the original owner of it. It's ready to bolt up to anyone that has a 7-bolt motor that want's to convert to an air cooled oil filter housing instead of the standard water cooled. You just need the actual cooler and then the -8AN lines to route it.

Asking $190 for the OFH package. Guy on DSMLink is pondering it so act fast if you want it!

If you have any questions, just let me know. PM me here if you are interested.